Question 1

How often do fire doors need to be inspected?

Accepted Answer

Under the Fire Safety (England) Regulations 2022, fire doors in the common parts of residential buildings over 11 metres must be checked at least every three months (quarterly). Flat entrance doors that are the responsibility of the building’s responsible person must be checked annually. These are minimum legal frequencies — if your fire risk assessment identifies issues, more frequent checks may be recommended. Buildings below 11 metres are not covered by the quarterly requirement, but the Regulatory Reform (Fire Safety) Order 2005 still requires fire doors to be maintained in working order.

Question 2

What does a fire door inspection involve?

Accepted Answer

The inspector checks that each fire door closes fully into its frame under its own power (self-closing device), that intumescent strips and smoke seals are present and undamaged, that glazing is intact and correctly fire-rated, that hinges are secure and not worn, that the door leaf is free of holes or damage, that the gap between the door and frame is no more than 3–4mm, and that the latch engages properly. Any door that fails on any of these points is recorded and a remedial action is recommended with a priority rating.

Question 3

What is the difference between a fire door check and a fire door survey?

Accepted Answer

A fire door check is the routine quarterly or annual inspection required by the 2022 Regulations — it focuses on whether the door is in working order and identifies obvious defects. A fire door survey is a more comprehensive assessment, often carried out by an FDIS-certificated inspector, that examines the door’s certification, installation quality, compatibility of components (ironmongery, seals, glazing), and overall fire performance. A survey is typically recommended when doors are first installed, after significant building works, or when the fire risk assessment calls for a detailed review.

Question 4

Who is responsible for inspecting fire doors in a block of flats?

Accepted Answer

The ‘responsible person’ under the Regulatory Reform (Fire Safety) Order 2005 is responsible. In a block of flats, this is usually the freeholder, building owner, or managing agent. For HMOs, it is the landlord or licence holder. The responsible person can carry out routine checks themselves if they are competent, but many instruct an FDIS-certificated inspector for comprehensive surveys and to ensure defensible records. Flat entrance doors that are owned by individual leaseholders may fall outside the responsible person’s direct control, but the 2022 Regulations give the responsible person a duty to make best efforts to inspect them.

Question 5

What happens if fire doors fail an inspection?

Accepted Answer

Failed doors must be repaired or replaced as a priority. Minor issues such as missing seals or a faulty self-closer can often be remedied on-site during or shortly after the inspection. Doors with structural damage to the leaf, incorrect certification, or non-fire-rated glazing will typically need full replacement. The inspection report will categorise each defect by risk priority. Failure to act on identified defects could result in enforcement action by the fire and rescue service, including prohibition notices that can restrict the use of the building.

Question 6

What is the difference between FDIS and BAFE certification for fire door inspectors?

Accepted Answer

FDIS (Fire Door Inspection Scheme) is the gold standard specifically for fire door inspection — inspectors complete rigorous training on fire door components, installation standards, and defect identification, and are assessed by an independent certification body. BAFE (British Approvals for Fire Equipment) is a broader fire safety accreditation scheme; its SP205 standard covers fire risk assessment, while some BAFE-registered companies also carry FIRAS accreditation for fire door installation and maintenance. When choosing an inspector, FDIS certification gives you the highest assurance that the inspector specialises in fire doors. BM TRADA Q-Mark is another respected scheme that certifies both fire door manufacturers and inspectors. For defensible compliance records, instruct an inspector holding at least one of these three certifications.

Fire Door Inspection Providers

Fire Door Inspection by Borough